First measure the size of the room and install it according to the size.
1. The floor must be clean, dry, stable, flat and free of furniture before installation.
2. Construction workers should choose the installation effect according to the customer's requirements, adjust the direction of the floor reasonably and scientifically, lay the moisture-proof mat of the floor first, and then start from the corner of the wall to lay the side of the floor with the convex groove against the wall, and insert 8 mm wooden dowels between the floor and the wall to make the floor have space for expansion and contraction.
3. Fishbone paving method: first cut off the front mouth 45 degrees, then install the first floor, and align the front mouth groove with the small end convex groove of the reverse mouth at 90 degrees for assembly.
4. Use a patting board and a hammer to beat the floor to piece the floor together to avoid gaps.
5. After the floor is installed, remove the temporary wooden dowels to ensure that there are expansion joints, install the skirting board, and the bottom of the skirting board is tightly combined with the floor surface.
6. When laying the floor on the keel designed with geothermal pipes, the vertical joint part of the floor must be laid on the keel. The width of the keel shall not be less than 45mm, and the center interval of each keel shall not be greater than 300mm.
